{"id":60,"date":"2016-06-03T16:43:12","date_gmt":"2016-06-03T16:43:12","guid":{"rendered":"http:\/\/surplusrifleguide.com\/?page_id=60"},"modified":"2016-10-02T14:38:05","modified_gmt":"2016-10-02T14:38:05","slug":"cz-52","status":"publish","type":"page","link":"https:\/\/surplusrifleguide.com\/index.php\/cz-52\/","title":{"rendered":"CZ-52"},"content":{"rendered":"

CZ-52<\/p>\n

\"ACZ52 \"CZ52<\/p>\n

Length: \u00a0 \u00a0 \u00a0 \u00a0 \u00a0 \u00a0 \u00a0 \u00a0 \u00a08.25 inches<\/p>\n

Barrel Length: \u00a0 \u00a0 4.5 inches<\/p>\n

Caliber: \u00a0 \u00a0 \u00a0 \u00a0 \u00a0 \u00a0 \u00a0 \u00a0 7.62x25mm<\/p>\n

Weight: \u00a0 \u00a0 \u00a0 \u00a0 \u00a0 \u00a0 \u00a0 \u00a0 34.5 oz<\/p>\n

The CZ-52 is a roller-lock semi-automatic pistol of Czech design. \u00a0The pistol features an 8 round magazine and a caliber that can defeat Level III body armor. \u00a0The safety switch features a de-cocker, however, there have been some reports of the de-cocker failing and actually discharging the weapon. \u00a0The firing pins are also particularly weak and dry firing is not recommended.<\/p>\n

Widely available commercially up through approximately 2010. \u00a0These started drying up and have increased in price in the US to about $300 for a nice one. \u00a0The black finish (as pictured) is featured on pistols that have been arsenaly refinished. \u00a0The original finish was a gray parkerizing type and tended to wear easily. \u00a0Usually the original finish commands a slight premium, particularly if it is in good condition.<\/p>\n

An unfounded rumor on the internet about this pistol is that it cannot handle the pressures of surplus rounds. \u00a0I have not found that to be the case. \u00a0Although it would not be able to handle proofing rounds, the pistol should be able to handle any surplus round of a standard pressure. \u00a0The Czechs would not have produced a pistol that could not handle their issued\u00a07.62x25mm rounds.<\/p>\n

As shown below, the CZ 52 can easily be rebarrelled for 9mm. \u00a0The standard CZ 52 magazines will work for this conversion and no fitting is required. \u00a0I would note that the barrels did occasionally fail to give a full positive ejection, probably due to US commercial 9mm ammunition having a much lower pressure than the caliber that the pistol was originally chambered for. \u00a0These barrels were made to take advantage of the more plentiful 9mm ammuntion, but they are not widely available anymore.<\/p>\n

\"9mm<\/p>\n

The following manual provides complete takedown and maintenance instructions:
\n